Description - Emser Tile Venetian Pebble is inspired by the beauty of Venice. These flat pebbles come on a mesh interlocking sheet at 12”x12” which can be installed in both residential and commercial applications. Works great for a fireplace facade and is also approved for shower wall and floor tile. The Venetian Pebble with surely bring a traditional, historic look to a interior space.
||12" x 12" Sheet
||Floors, Walls, Countertops
|Shape of Tile
|Made in USA
Product Codes – M18VENECO1212MF, M18VENEGR1212MF, M18VENEGR1212MFP11, M18VENEIV1212MF, M18VENEIV1212MFP11, M18VENEMC1212MF, M18VENEMC1212MFP11, M18VENETA1212MF, M18VENETA1212MFP11, M18VENEGO1212MF, M18VENEIT1212MF, M18VENEPA1212MF, M18VENE4C1212MF, M18VENE4C1212MFP11, SWM18VENEME1212MF, M18VENEME1212MF, M18VENEGE1212MF, M18VENECH1212MF, M18VENESI1212MF
Available For Order - Ships between Aug 15 - 17
Porcelain & Ceramic tiles are easy to keep clean and maintain. Maintenance of the floor typically includes:
General instructions for installing floor tile:
- Tile must be installed over structurally sound substrates. Any damaged, loose or uneven areas must be repaired, patched and leveled.
- Start by marking the center point of the room. Place a row of loose tiles along the center lines in both directions, leaving enough space for uniform joints (use tile spacers).
- Using the notched side of the recommended trowel, comb adhesive into standing ridges by holding the trowel at a 45-degree angle. Remove excess adhesive, leaving a uniform, ridged setting bed. Never spread a larger area that can be set in 15 minutes.
- Measure tiles to be cut carefully and mark with a pencil or felt-tip pen. Make straight or diagonal cuts with a tile cutter and curved cuts with a nipper. Be sure to mix tiles from several cartons as you set, for a blended effect.
- Begin installation in the center of the room. Finish each grid before moving to the next. Start with the first tile in the corner of the grid and work outward. Set tiles one at a time using a slight twisting motion. Insert tile spacers as each tile is set. Fit perimeter tiles in each grid last, leaving 1/4" gap between tile and wall.
- When grid is completely installed, tap in all tiles with a rubber mallet or hammer and wood block, to ensure a good bond and level plane. Remove excess adhesive from joints with a putty knife, and from tile with a damp sponge.
- Do not walk on tiles until they are set (usually in 24 hours).
Tips for installing large format floor tile:
- Large size floor tile installation requires particular attention to proper subfloor preparation, grout joint sizing, trowel selection, and mortar coverage.
- It is absolutely critical that large tile be installed on a level substrate.
- Installation Requirement: For proper bonding, medium bed mortar should be used in installing tiles with a dimensional length greater than 15 inches on any one side of the tile. Back buttering tiles of this nature in the installation process will also assure proper coverage for body.
For detailed installation instructions, please Click Here.