Infinity Rx

Available For Order - Ships between Oct 23 - 30

• Daily or weekly vacuuming or dusting of dirt, grit, dust etc.
• Use felt pads under chair and furniture legs to prevent scratching of the flooring surface.
• Place doormats at all entrances to prevent tracked in dirt, rocks, moisture, and other debris.
• Avoid using rubber-backed mats as they can stain the flooring surface over time.
• When mopping, use a damp mop. Never a wet mop.
• Clean up spills immediately to prevent damage to the flooring surface.

• First you will want to clean your sub floor so that it is free of all dust, dirt, and debris.
• Loose lay your rolls in the room as you would like them to look after a complete installation. Let the rolls relax for up to 24-48 hours to ensure proper installation of your new flooring.
• Note: Rolls may be directional so make sure the color matches on each roll. If the roll colors do not match, flip them or turn them 180 degrees to ensure color matches.
• Make any necessary cuts to the rolls to fit them into the room using a Straight Edge and a Utility Knife with a fresh blade. We recommend leaving a gap around the rolls roughly the thickness of the rolls being used to account for expansion and contraction.
• Apply double sided tape to perimeter of each roll.
• Place rubber rolls back into position on top of the double sided tape.


B: Glue Installation
• First clean your sub floor so that it is free of all dirt, dust and debris. Also, when gluing your flooring down, it is recommended that the sub floor is free of any moisture.
• Loose lay your rolls in the room as you would like them to look after a complete installation. Let the rolls relax for up to 24-48 hours to ensure proper installation of your new flooring.
• Note: Rolls may be directional so make sure the color matches on each roll. If the roll colors do not match, flip them or turn them 180 degrees to ensure color matches.
• Make any necessary cuts to the rolls to fit them into the room using a Straight Edge and a Utility Knife with a fresh blade. We recommend leaving a gap around the rolls roughly the thickness of the rolls being used to account for expansion and contraction.
• Roll up the rolls at one end of the room. Put down a 10 foot long light layer of polyurethane adhesive and unroll 10 of the flooring into the adhesive at a time.
• Repeat this step for every 10 feet of roll length until the entire roll has been unrolled into it desired position.
• After all rolls have been glued down, it is often recommended to use a 100-pound roller on the floor in order to guarantee good adherence to the subfloor. If a roller is not available, walking on the flooring in small choppy steps may also work.


For printable installation instructions, please Click Here.