Nitro Garage Floor Tiles - 12" x 12" x 3/8"

Installation Instructions for Nitro Tiles

Preparation:

Ensure the subfloor is clean, dry, and free of debris. If installing over concrete, make sure it is cured (at least 30 days old) and dry.

Layout:

Plan the layout of the tiles before installation. Starting from the center of the room and working outwards will help achieve a balanced look.

Leave a 1/2" gap between the tiles and the walls, columns, cabinets, or any other fixed object. The tiles should sit snugly against each other — the gap belongs at the perimeter, not between the tiles.

Cutting Tiles:

Use a utility knife to cut tiles to fit around edges and corners. Measure carefully to ensure a precise fit.

Installation:

Place the tiles snugly against each other without gaps. Nitro Tiles are designed to interlock securely, so no adhesives are needed.

For areas where tiles might shift, consider using double-sided tape along the perimeter.

Finishing Touches:

After installation, walk over the tiles to ensure they are properly locked into place.

Note:

Nitro Tiles perform well as a floating floor when they cover the full floor area. For smaller areas that don’t cover the full floor, we recommend using adhesive or a rubber underlayment to help keep the tiles securely in place.

Why the gap matters:

Nitro Tiles are a floating floor. Hard plastic expands and contracts as garage temperatures swing between summer and winter, so the floor is built to move as one sheet rather than being fixed down. Two things make that work: every joint in the interlock carries a designed-in tolerance, and the 1/2" perimeter gap gives the whole field somewhere to go. Leaving no gap at the walls is what makes a plastic tile floor lift at the edges.

For long uninterrupted runs, or a garage that sees extreme temperature swings, Nitro Tile Expansion Joints let you build a relief joint into the field itself.

Care and Maintenance for Nitro Tiles

Regular Cleaning: 

• Sweep or vacuum the tiles regularly to remove loose crumbs, dust, or debris.
  
• Occasionally damp mop the tiles with a mild soap and water mixture. Common soaps include Dawn dish detergent or Tide laundry detergent.
  

Stain Management:

• Nitro Tiles are not stain-proof. Street tar can stain light-colored tiles but can typically be removed with a cleaner like Purple Power.
  
• Performance tires can also stain light-colored tiles. For tire marks, consider replacing the affected tiles or using darker tiles to disguise the stains. If stains persist, contact Customer Service at (866) 416-6388 for assistance.
  

Avoid Damage:

• These tiles can be damaged under the weight of a car jack. Use your car jack directly on concrete or place a plywood board or steel plate under the jack.
  
• If your garage receives a lot of sunlight, consider placing vented tiles at the entrance for added stability.
  

Color Variations:

• Nitro tile colors are produced in batches, leading to potential color variations between orders. It is advisable to order extra tiles to maintain continuity across your flooring.
  

General Tips:

• Regularly inspect the tiles for signs of wear or damage.
  
• Address spills promptly to prevent staining.