Description - Life Floor Slate Tiles are the perfect solution for providing flooring around pools, on decks, and patios where water may be present. These tiles, unlike other pool and deck flooring solutions, are crafted from both foam and rubber which not only gives you a soft floor, but one that is also very slip resistant. On top of these outdoor tiles being soft and slip resistant, they are also cool to the touch in direct sunlight and will keep their color in direct sunlight for the life of the product. The tiles are also anti-fungal and anti-bacterial making them perfect for locker rooms, bathrooms, showers, and many other areas where a safe flooring surface is needed. These tiles can be easily installed with the use of contact cement, double-sided tape or a polyurethane adhesive and can be installed underwater. With 7 different colors to choose from and a 5 year warranty, your pool, deck or patio floor are sure to be the talk of the neighborhood.
Note: Foam products can be punctured by sharp animal nails, rough use, high heels, and moving furniture.
Material – Life Floor foam tiles are made with patented EvaTrax technology which is a non-toxic, UV-stable foam-rubber.
Size – 2' x 2'
Thickness – 3/8 Inch nominal (~9.5mm)
Weight – Each mat weighs approximately 1.34 Lbs.
Recommended Uses – Life Floor Slate outdoor foam tiles have been designed to be a premium worry-free solution for barefoot traffic on wet surfaces. These tiles are perfect for outdoor pools, decks, patios, in showers, bathrooms, locker rooms, saunas, underwater in pools, playrooms, games rooms, and many other areas where a safe, non-toxic, slip-resistant floor is desired.
In Stock - Ships between Jun 26 - 27
Installation of Life Floor Slate Tiles is very easy and typically done by the customer. Instructions for installation of your new flooring are as follows:
- Measure the installation area to ensure you have enough tiles to cover the desired area.
- Find the center point of the installation area and mark and 'X' at this point
- Without applying any adhesive, lay the tiles out as you would want them to lay in the room without cutting any pieces. Ideally, start from the center of the room where you have marked the 'X'.
- Once you have completed the entire layout without adhesive, begin the adhesion process in the center of the room.
- Using a general paintbrush, evenly apply contact cement on the back of the tile and to the substrate where the tile will fit.
- Let both the back of the tile and the substrate area cure for approximately 5 minutes until the contact cement is tacky.
- Begin by laying down the tile one edge at a time. For all tiles after the first, align the edges tightly to the surrounding tile edges.
- Ensure each corner and edge are secure by applying pressure with the thumb and index finger.
- Using a general roller, apply pressure to the entire tile to secure the tile to the substrate.
- Tiles on the outer perimeter of the room may need to be cut to fit the space. Measure and cut accurately to ensure proper fit.
- If tile is installed in a wet area with drains, cut area over the drain to ensure proper drainage. In addition, you may drill holes in the tiles to allow water to drain through the tile.