Questions & Answers — Helios Composite Deck Tiles

Back to Helios Composite Deck Tiles

Viewing 1–5 of 5 questions

• Q: How many Helios Deck Tiles do I need?

  A: One tile per square foot. Each tile is 12" x 12" and 11.5" x 11.5" once interlocked, and covers 1 square foot. A 10 by 12 foot patio takes 120 tiles. Add about 5% for cuts along walls and around posts. Each tile weighs about 2 pounds.

  Was this helpful?▲0Yes, helpful▼0No, not helpful

• Q: Can Helios Deck Tiles be used around a pool or in a shower?

  A: Yes. The tiles sit on raised tabs, so water drains underneath instead of pooling on the surface. They are rated for outdoor use and resist mold, mildew and moisture. Pool decks, shower floors, hot tub walk-off areas, patios and entryways all work. They are heat and frost resistant, so they handle seasonal temperature swings outdoors.

  Was this helpful?▲0Yes, helpful▼0No, not helpful

• Q: How do I install Helios Deck Tiles?

  A: No adhesive needed. The tiles interlock and lay loose, so you can take them up again. Start with a clean, dry, level and stable surface. Begin in the front left corner with the female loop side facing away from the edge. Work along two edges, then fill the middle with whole tiles, checking that each one locks to its neighbor. Cut tiles at walls with a sharp utility knife. Leave a 3/4" gap at the edges for expansion.

  Was this helpful?▲0Yes, helpful▼0No, not helpful

• Q: How much weight can Helios Deck Tiles hold?

  A: About 1,623 pounds per square foot before they break, which is 7.22 kilonewtons per square foot. That covers patio furniture, planters and normal foot traffic. The tiles are a composite of 100% recycled bamboo and resin, textured to look like wood slats or grass. The composite resists fading, insects, scratches and mildew.

  Was this helpful?▲0Yes, helpful▼0No, not helpful

• Q: How do I clean Helios Deck Tiles?

  A: Sweep or vacuum loose debris, then hose the tiles off or damp mop with mild soap and water. Hard water leaves spots, so use distilled water where you can. To remove existing stains, mix 2 parts vinegar into 1 gallon of distilled water. Pour it over the tiles and scrub with a soft-bristled brush. Rinse with distilled water and let the tiles air dry.

  Was this helpful?▲0Yes, helpful▼0No, not helpful