Please note: trim images are an example of shape and size. Images are not necessarily specific to this particular product. Moldings are not created to be an exact match, but as a complement to the overall color & finish of the floor. Grain and color variation should be expected.
CoreTecCoreTec

COREtec Plus XL 9" Waterproof Vinyl Planks

loader
Loading...
  • IIC 62, STC 62, R Value 057
  • Whittier Oak ships same or next business day from TN
  • Will not interlock with floors ordered before 11/2015
  • Montrose Oak out of stock until 7/9/2016.
  • Underlayment attached.
View All

More Information

COREtec Plus XL planks are the ultimate flooring solution when it comes to commercial and residential environments. Fully waterproof, this resilient engineered vinyl floor can be installed in any room and on any level. With a durable 20mil wear layer, cork underlayment attached, and a lifetime structural warranty, these floating floor planks are the "mac daddy" of all the flooring options.

Details

  • No
Installation is simple and is commonly done by our customers. Installation of waterproof planks and tiles is as follows: Complete any necessary floor prep. Start with the tongue side facing the wall. After the initial starter board, press the end seam of the second plank into the end seam of the first plank, and then lock them together by laying the plank down. Continue working left to right. Install the first plank in the second row by inserting the tongue into the groove of the plank in the first row. This is best done with a low angle of the plank. Insert the long side seam at a slight angle first. As the top surfaces meet, rotate the plank down into the locked position. Engage the end seam, using a rubber mallet if necessary. Planks may be cut with the use of a crosscut power saw. Continue installing planks removing any gaps using a tapping block and a scrap of flooring to cover the tapping block. Be careful not to damage In*Step tongue and groove. Protect all exposed edges by installing wall molding and/or transition strips. Make sure that no plank will be secured in any way to the subfloor.
Maintenance of the floor typically includes: Daily or weekly vacuuming or dust mopping of dirt, grit, dust etc. Use felt pads under chair and furniture legs to prevent scratching of the flooring surface. Place door mats at all entrances to prevent tracked in dirt, rocks, moisture, and other debris. Avoid using rubber backed mats as they can stain the flooring surface over time. When mopping, use a damp and never a wet mop. Clean up spills immediately to prevent damage to the floor.
Limited Lifetime Residential. 15-Year Limited Commercial.

Reviews

Questions

Customer Questions And Answer
Clean up spills immediately. You can sweep or vacuum the floor regularly to remove loose dirt. Do NOT use vacuums that use a beater bar or turn beater bar off.
loader
Loading...
The pattern repeat on COREtec Plus® XL planks is 4 planks.
loader
Loading...
The Coretec will interlock with one another. The ONLY one that will not interlock with the others is the XL plank.
loader
Loading...
While COREtec Plus products feature a 20 mil durable wear layer, no vinyl product is 100% scratch proof. We recommend trying to keep the dog's nails trimmed to help lessen the amount of scratches. If you need to fix a scratch, you can use a repair putty that is approved for vinyl floors to help fill it in.
loader
Loading...
Coretec is approved for installation over radiant floors.
loader
Loading...
Do NOT use detergents, abrasive cleaners or “mop and shine” products.
loader
Loading...
Sweep, dust mop or vacuum the floor to remove all loose dirt and grit. A robot vacuum should be fine.
loader
Loading...
This product can be glued down. Please see our installation instructions above for further information.
loader
Loading...
It is approved, but needs to be ½” plywood over top and the temperature of the subfloor can’t get above 85 degrees.
loader
Loading...
We recommend using products specifically recommended for use outdoors.
loader
Loading...
This product is not rated or recommended for outdoor use.
loader
Loading...
We have no specific recommendations for installation of the COREtec in a vertical application. Also, it is designed as a flooring material for indoor, climate controlled use only. It is not designed for use outside, or at the bottom of a swimming pool. While you could certainly install it that way if you want to, there would be no warranty coverage on the material or the installation.
loader
Loading...
Heavy furniture and appliances should be equipped with non-staining large surface floor protectors. This helps to disperse the weight on the floor.
loader
Loading...
Any spills should be cleaned up quickly as detailed in the Coretec maintenance PDF.
loader
Loading...
Coretec planks can definitely help to hides some subfloor imperfections. Please see the detailed installation PDF for further information on the subfloor details.
loader
Loading...
You must stagger vinyl planks for proper installation. Do not stagger/line planks up evenly.
loader
Loading...
COREtec can go right over your floor.
loader
Loading...
Coretec can be installed in large spaces without t-molding or expansion gaps.
loader
Loading...
Coretec XL is a larger planks size.
loader
Loading...
The COREtec Pro Plus will be better able to handle the weight of a piano that size, than the regular COREtec Plus; however, we would still recommend putting something rigid 1 1/2 - 2" bigger around than the base to help distribute the weight.
loader
Loading...
The manufacturer informed us that it's between 60%-70%.
loader
Loading...
Southern exposure rooms will hold up to sunlight, however, we recommend gluing the material in that area to prevent any issues (material will handle up to 140° radiant). This can be done by using a cork compliant adhesive and a 1/16” x 1/16” notch trowel. Glue down the areas where the sunlight reaches into the room and go 2ft past to allow stability in room temperature variance from direct sunlight to indirect. The adjoining material can be simply be clicked together and float installed throughout...
Southern exposure rooms will hold up to sunlight, however, we recommend gluing the material in that area to prevent any issues (material will handle up to 140° radiant). This can be done by using a cork compliant adhesive and a 1/16” x 1/16” notch trowel. Glue down the areas where the sunlight reaches into the room and go 2ft past to allow stability in room temperature variance from direct sunlight to indirect. The adjoining material can be simply be clicked together and float installed throughout the remaining area. This flooring is suitable for stairs, please see the appropriate moldings that we offer to properly install and finish edges of stairs, listed under "Accessories" on the product page.
loader
Loading...
These planks (or any vinyl plank) can be installed on a carpet, if the carpet is a tight, low pile style. They cannot be installed over a high pile carpet since the “squish” of a plush carpet will prevent vinyl planks from locking properly.
loader
Loading...
loader
Loading...
loader
Loading...
x