Description - 700 Series Wall Base molding adds a finishing touch to any space by covering up the expansion gap between your floor and your walls. This wall basing is durable, contains bio-based phthalate free plasticizer, is moderately flexible, and is easy to install around columns and corners.
Material – This 100% thermoplastic rubber wall base is PVC free, Phthalate Free, will not shrink, gap or cup, is FloorScore Certified, and qualifies for LEED Credits.
Length – Sold in length of 4'
Thickness – 1/8" (3.2mm)
Height – Available in several heights
Recommended Uses – Can be used to cover the expansion area and floor to wall transitions with most flooring types.
Available For Order - Ships between Jun 22 - 26
Installation of moldings is very simple and typically done by the consumer. Typical installation of these moldings is as follows:
- Molding should be installed after floor is in place. Flooring and walls should be properly clean and dry to ensure a secure installation.
- Wall base may be installed on interior plaster, gypsum wallboard, concrete, masonry, mineral-reinforced cement board or similar porous surfaces.
- Cut the wall base to finished length and miter cut the ends for inside and outside corners.
- Secure to wall using an acrylic cove base adhesive. Clean up any excess adhesive prior to drying.
9,707+ Verified Reviews
Over 200 Million Sqft
30 Day Money Back
Free Samples
