Details Details

Description - Daltile Wellsridge 7.5" Rigid Core Vinyl Planks feature SPC vinyl planks in natural wood looks with high graphic variation and texture. These rigid core vinyl planks are easy to install and are practically maintenance free. Excellent thermal insulation and superior sound attenuation are just a few of the perks of this unprecedented powerful product.

Material – SPC.

Specs

Plank Width	7.5”
Plank Length	48”
Attached Underlayment	Yes
Edges	Square
Thickness	6mm
Phthalates	None

Gloss	Low
Installation Type	Float, Direct Glue
Installation Location	On, Above, Below
Waterproof	Yes
Locking System	Click
Radiant Heating Approved	Yes

Core	Rigid Core
Style	Wood Look
Wear Layer	20 mil
Residential Warranty	Lifetime limited
Commerical Warranty	15 Year Limited
Bevel	Painted

Plank Variation – 13 Unique Planks.

Recommended Uses – Daltile Wellsridge 7.5" Rigid Core Vinyl Planks are good for light to medium indoor commercial and medium to heavy indoor residential use. We do not recommend using these as a shower floor.

Available For Order - Ships between May 27 - Jun 3

Vinyl tiles and planks are easy to keep clean and maintain. Maintenance of the floor typically includes:

Daily or weekly vacuuming or dropping of dirt, grit, dust etc.
Use felt pads under chair and furniture legs to prevent scratching of the flooring surface.
Place door mats at all entrances to prevent tracked in dirt, rocks, moisture, and other debris.
Avoid using rubber backed mats as they can stain the flooring surface over time.
When mopping, use a damp and never a wet mop.
Clean up spills immediately to prevent damage to the floor.

Installation is simple, and is commonly done by our customers. Installation of interlocking vinyl planks is as follows:

Complete any necessary floor prep.
Start with the tongue side facing the wall.
After the initial starter board, press the end seam of the second plank into the end seam of the first plank, and then lock them together by laying the plank down. Continue working left to right.
Install the first plank in the second row by inserting the tongue into the groove of the plank in the first row. This is best done with a low angle of the plank.
Insert the long side seam at a slight angle first. As the top surfaces meet, rotate the plank down into the locked position. Engage the end seam, using a rubber mallet if necessary.
Planks may be cut with a utility knife using the “score and snap” technique, or with the use of a crosscut power saw.
Continue installing planks removing any gaps using a tapping block and a scrap of flooring to cover the tapping block. Be careful not to damage tongue and groove.
Protect all exposed edges by installing wall molding and/or transition strips. Make sure that no plank will be secured in any way to the subfloor.

For more detailed installation instructions, please Click Here.

Daltile Wellsridge 7.5" Rigid Core Vinyl Planks

Ask a Question

Question Sent