Daltile Emerson Wood Mosaic

Description Daltile's Emerson Wood Mosaic features a modern 3D cube mosaic pattern set on a 11-1/2" x 11-1/2" Sheet. This 3D pattern features StepWise technology and is made in the USA. This collection is available for multiple installation locations including outdoor, walls, backsplash and countertops.

Coordinates With – Daltile Emerson Floor Tiles

Specs
Material	Colorbody Porcelain
Tile Size	11-1/2" x 11-1/2" Sheet
Visual	Wood
Installation Location	Floors, Walls, Countertops
Scratch Hardness (MOHS)	8.0

Chemical Resistant	Yes
Shade Range	Random V4
Slip Resistant	Yes
Shape of Tile	Cubic
Made in USA	Yes

Grout Options
Good:	Polyblend Sanded Grout
Better:	Prism SureColor Grout
Best:	Fusion Pro Grout

Product Codes – EP0122, EP013, EP0322, EP033, EP0422, EP043, EP0522, EP053, EP0622, EP063, EP01, EP03, EP04, EP05, EP06.

Available For Order - Ships between Oct 28 - Nov 4

Ceramic tiles are easy to keep clean and maintain. Maintenance of the floor typically includes:

Daily or weekly vacuuming or mopping of dirt, grit, dust, etc.
Place doormats at all entrances to prevent tracked in dirt, rocks, moisture, and other debris.
Glazed tiles should be cleaned routinely with an all-purpose, low VOC household or commercial cleaner.
The entire area should be cleaned and scrubbed with cleaner solution by using a cotton mop, cloth, sponge, or non-metallic brush.
Routine cleaners should never contain hazardous or polluting products including, but not limited to acids or ammonia. Acids can damage the grout and the glazed surface of the tile, while ammonia can cause discoloration of grout.
When complete, be sure to rinse the entire area with clean water to remove all cleaning solution residue.

For detailed cleaning instructions, please Click Here.

General instructions for installing mosaic Tile:

Tile must be installed over structurally sound substrates. Any damaged, loose or uneven areas must be repaired, patched and leveled.
Start by Dry-fit tiles before adhering to determine the pattern. Sheet tiles can be cut with a utility knife along the grout lines to match up to the inlay tiles.
Once a pattern is set, use a tape measure to center the design in the room.
Mark corners with a pencil then pick all the tiles back up. Snap chalk lines from corner to corner to make a box for the field tile.
Mix thin-set to a peanut butter consistency. Allow it to rest for about 10 minutes. Spread thin-set in the area using a 1/4 x 1/4 square notch trowel, then begin to set tiles.
Backbutter the border or inlay tiles using a margin trowel and set them in place.
Use a wet saw to cut the field tiles against the wall to size. To make small cuts, such as cuts to go around a radiator, use a tile nipper.

For printable warranty information, please Click Here.

Click for printable spec sheet.

Related Products

Customer Questions & Answers

Ask a Question

Question Sent