Description - Daltile Langton 7.5" Flex Vinyl Planks offer striking wood patterns with a 20mil strong wear layer, making them an ultra beautiful and super strong vinyl flooring option. The colors and textures will remind you of Scandinavian style and aesthetic.
Material – 100% vinyl.
||Float, Direct Glue
||On, Above, Below
|Radiant Heating Approved
||10 Year Limited
Plank Variation – 13 Unique Planks.
Recommended Uses – Daltile Langton 7.5" Flex Vinyl Planks are good for light to medium indoor commercial and medium to heavy indoor residential use. We do not recommend using these as a shower floor.
Available For Order - Ships between Sep 29 - Oct 6
Vinyl tiles and planks are easy to keep clean and maintain. Maintenance of the floor typically includes:
- Daily or weekly vacuuming or dropping of dirt, grit, dust etc.
- Use felt pads under chair and furniture legs to prevent scratching of the flooring surface.
- Place door mats at all entrances to prevent tracked in dirt, rocks, moisture, and other debris.
- Avoid using rubber backed mats as they can stain the flooring surface over time.
- When mopping, use a damp and never a wet mop.
- Clean up spills immediately to prevent damage to the floor.
Installation is simple, and is commonly done by our customers. Installation of interlocking vinyl planks is as follows:
- Complete any necessary floor prep.
- Start with the tongue side facing the wall.
- After the initial starter board, press the end seam of the second plank into the end seam of the first plank, and then lock them together by laying the plank down. Continue working left to right.
- Install the first plank in the second row by inserting the tongue into the groove of the plank in the first row. This is best done with a low angle of the plank.
- Insert the long side seam at a slight angle first. As the top surfaces meet, rotate the plank down into the locked position. Engage the end seam, using a rubber mallet if necessary.
- Planks may be cut with a utility knife using the “score and snap” technique, or with the use of a crosscut power saw.
- Continue installing planks removing any gaps using a tapping block and a scrap of flooring to cover the tapping block. Be careful not to damage tongue and groove.
- Protect all exposed edges by installing wall molding and/or transition strips. Make sure that no plank will be secured in any way to the subfloor.
For more detailed installation instructions, please Click Here.