Description - Backed by a waffle pattern that creates air pockets to diffuse sound and vibrations, these gym tiles offer any space the highest level of protection and sound absorption. Made with an anti slip diamond tread surface that water cannot penetrate, our 3/4” Shock Tiles provide a gym floor that will not promote mold, mildew, or bacterial growth. Available in center, border, and corner tiles these shock absorbing tiles can be easily installed in any commercial or residential space.
Material – 3/4" Shock Tiles are constructed of vulcanized recycled rubber buffings.
Size – 2' x 2' (Interlocked size - 22.5" x 22.5")
Thickness – 3/4 Inch.
Weight – Each tile weighs approximately 16 Lbs.
Recommended Uses –
The 3/4” Shock Mats are perfect as garage gym tiles and tiles for cross fit. They have also been used as flooring for commercial gyms, home gym flooring, tiles under equipment, flooring for bumper plates, flooring for Olympic platforms, power lifting tiles, anywhere free weights will be dropped and much more.
In Stock - Ships between Sep 16 - 17
3/4" Shock Tiles are very easy to maintain and keep clean. Maintenance of these interlocking gym tiles typically includes:
- Vacuuming any loose crumbs, dust, or debris from the tile flooring surface when necessary.
- Occasional damp mopping of the floor tile with a mild soap and water solution. A few recommended soaps are Dawn dish detergent or Tide laundry detergent.
Note: Do not use any solvent or oil style cleaners such as Pinesol, Lysol, Murphy’s Oil Soap, WD40, paint thinner, etc. since these types of cleaners will break down the flooring over time.
For more detailed cleaning instructions and commercial cleaning instructions, Click Here.
Installation of interlocking tiles is very simple and typically done by the consumer. Typical installation of these tiles is as follows:
- First, clean your sub floor so it is free of all dirt, grease or debris.
- Snap a chalk line on the sub floor 24” from one wall in your room. Snap another chalk line on the subfloor 24” from an adjacent wall. You should now have a pair of perpendicular lines making an approximate 90-degree angle.
- Begin laying the interlocking tiles along the chalk lines, snapping the locks together as you go.
- Leave the perimeter of the room open until the field is installed.
- After the field is covered, go back and cut in tiles along the walls in the room. It is recommended to leave a gap along the wall roughly the thickness of the tiles being used to account for expansion and contraction of the floor in varied temperature ranges.
Note: When piecing interlocking tiles together, adhesives are usually not used since the weight of the locked together product is usually enough to keep the floor tiles from moving. However, if you do experience movement and would like to ensure that the tiles do not slide at all, some double-sided tape or mat tape can be used around the perimeter of the installation to prevent any movement.
For printable installation instructions, please Click Here.